|
Re: Penny
During a couple evenings last week, dad and I worked on getting the engine and transmission back in the truck. New clutch, new flywheel, all bolted together, and swung into place. Looks right at home there!
Also discovered that I should’ve tried to track down a correct bellhousing instead of using one from a 60s truck. I didn’t think to check where the clutch z-bar landed on the drivetrain side and just assumed it was the block. Whoops. So next step will be making a bracket that’ll mount off the two spots in the block and stick past the rear so that the z-bar can fit in the correct spot
__________________
Christian Carpenter
1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit
1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed
1995 Dodge Dakota Sport
"I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson
|