|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-05-2024, 06:32 PM
|
#1 |
|
Registered User
Join Date: Oct 2020
Location: ca
Posts: 106
|
what size motor mount shims needed?
i just replaced newish rubber motor mounts with poly ones. my engine still sits too low. what size spacers should i try? i need to bring up the motor 1/2 to 3/4 of an inch.
|
|
|
|
09-05-2024, 09:21 PM
|
#2 | |
|
Senior Member
 
Join Date: Jul 2000
Location: North Texas
Posts: 3,571
|
Re: what size motor mount shims needed?
Quote:
BTW, ideally the the carb would be level, or close to it.
__________________
Mike 1969 C10 LWB -- owned for 35 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes. 1982 C10 SWB -- sold 1981 C10 Silverado LWB -- sold, but wish I still had it! 1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming. Retired as a factory automation products salesman. Worked part-time over the years for an engine builder and a classic car repair shop. Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then! Last edited by MikeB; 09-06-2024 at 09:20 AM. |
|
|
|
|
|
09-05-2024, 10:08 PM
|
#3 |
|
Registered User
Join Date: Dec 2017
Location: Elkhart, Texas
Posts: 1,810
|
Re: what size motor mount shims needed?
As they came from the factory, shimming the motor mounts was not required.. Either those poly mounts are incorrect, or something is amiss with the frame brackets.. What are you referencing to determine correct engine height??
|
|
|
|
|
09-05-2024, 11:20 PM
|
#4 |
|
Who Changed This?
Join Date: Jan 2013
Location: Simi Valley, CA
Posts: 10,608
|
Re: what size motor mount shims needed?
Pics needed.
__________________
~Steven '70 Chevy 3/4T Longhorn CST 402/400/3.56 Custom Camper Simi Valley, CA |
|
|
|
|
09-07-2024, 12:23 PM
|
#5 |
|
Proprietor of Dale's Corner
Join Date: Nov 2012
Location: Vacaville , CA
Posts: 16,243
|
Re: what size motor mount shims needed?
I have never needed shims. Pics are definitely needed...
__________________
"Some Days Chickens And Some Days Feathers" Dale XNGH ECV Sam Brannan 1004 R.I.P. 67ChevyRedneck R.I.P. Grumpy Old Man R.I.P. FleetsidePaul |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
