bed wood - The 1947 - Present Chevrolet & GMC Truck Message Board Network

62 short step · 12-23-2006, 12:15 PM

Hey guys need a little info here. Looking for something to put for the bed floor. I did not want to do the traditional wood floor because I plan on using it as a truck. I want to use some 3/16 steel diamond plate, but I need a 3/4 filler to put where the original floor was. I thought about using 3/4 treated ply wood, but with the new chemicals it eats through metal. I wonder if I primed the treated ply wood with a good primer if it would not eat the metal? Any suggestions?

12-23-2006, 12:15 PM	#1
62 short step Senior Member Join Date: Aug 2005 Location: Greenwell Springs, Louisiana Posts: 2,882	bed wood Hey guys need a little info here. Looking for something to put for the bed floor. I did not want to do the traditional wood floor because I plan on using it as a truck. I want to use some 3/16 steel diamond plate, but I need a 3/4 filler to put where the original floor was. I thought about using 3/4 treated ply wood, but with the new chemicals it eats through metal. I wonder if I primed the treated ply wood with a good primer if it would not eat the metal? Any suggestions? __________________ www.louisianaclassictruckclub.com 1965 c-10 86 chevy c/k 20

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.