![]() |
|
![]() |
#1 |
Registered User
Join Date: Jul 2010
Location: phoenix az
Posts: 60
|
carb whistling
so my carb started to whistling when i went to adjust it. anyone have this before ???
|
![]() |
![]() |
![]() |
#2 |
Who Me?
Join Date: Sep 2010
Location: Royal Palm Beach, FL
Posts: 4,067
|
Re: carb whistling
Make sure all your vacuum lines are connected. Sounds like a vac leak somewhere.
__________________
![]() 1997 Tahoe LT 4D 2WD (DD) 2001 Blazer 4D 2WD 1961 Apache 10 (sold) 1965 C10 Stepper (sold) |
![]() |
![]() |
![]() |
#3 |
Registered User
![]() Join Date: Aug 2010
Location: Burbank CA
Posts: 3,055
|
Re: carb whistling
Maybe it was just happy to be getting some attention.
![]() |
![]() |
![]() |
![]() |
#4 |
Registered User
![]() Join Date: Jan 2008
Location: Pell City, AL
Posts: 255
|
Re: carb whistling
Base plate gasket (carb to manifold). If it's one of those thin paperboard ones I'd look there. Use a thicker cardboard gasket and some (thin layer) RTV.
|
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Jul 2010
Location: phoenix az
Posts: 60
|
Re: carb whistling
who makes the thicker cardboard gasket i can only find the thin ones.
|
![]() |
![]() |
![]() |
#6 |
Registered User
![]() Join Date: Jan 2008
Location: Pell City, AL
Posts: 255
|
Re: carb whistling
Most carb kits come with the thicker ones. You may get by with some RTV on your finger, smeared around the base.... if you're not too fussy about those things. Spray some carb cleaner or open a propane bottle (slowly) near the gasket around the base... if the RPM goes up, you have a leak. Smear some RTV there.
|
![]() |
![]() |
![]() |
#7 |
Registered User
Join Date: Nov 2008
Location: Lacombe, LA
Posts: 2,772
|
Re: carb whistling
While it works?
__________________
http://s1299.photobucket.com/user/jb...23904108567829 |
![]() |
![]() |
![]() |
#8 |
Senior Member
![]() Join Date: Nov 2008
Location: Gresham , Oregon
Posts: 588
|
Re: carb whistling
I agree with others , carb spray or a little propane really works ... Ck. vacumn lines , ( infact as you pull each vacumn line off .. take a razor and recut and fit back on , that way the hose isn't swallon at the end and you have a clean cut and fit ) .. carb base , carb bolts tight on manifold , tighten all screws both on top and underneath carb if pulled , ck. throttle shaft bushings ... just covering the bases .. Good Luck ...
Last edited by 62 Longbed; 04-20-2011 at 03:48 PM. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|