TX WTB Bed Patch Panel Dallas

[Big-Blue]

Don't send that bed to the scrap yard yet! In need of a bed patch about 8" x 48", long ways across the bed. I bought one from LMC and it was an absolute joke. Not even close to matching the existing.

I can pick up if you are around Dallas.

[Darren MagooGardner]

I have a swb bed ready for the scrap yard. It may have what you need. the pass front 1/4 panel has been cut out and sold. thanks

[Big-Blue]

I should have mentioned it's the floor I am looking for. Do you have floor left or was it wood?
Posted via Mobile Device

[Ol Blue K20]

Show me a pic I just cut up a floor cross ways may have a piece that will work for ya

[Big-Blue]

I am out of town but its about 8" tall right between the wheel wells. I could use two at 8" x 24" anywhere from your bed. I will send a pic tomorrow.
Posted via Mobile Device

[Ol Blue K20]

Originally Posted by Big-Blue

I am out of town but its about 8" tall right between the wheel wells. I could use two at 8" x 24" anywhere from your bed. I will send a pic tomorrow.
Posted via Mobile Device

Yeah send a pic to confirm I understand, but I think I do and will make sure I didnt cut too narrow

[Big-Blue]

This is what I need to patch. It's actually a little over five inches tall so a 6" tall piece would give me enough to trim and fit.

[Ol Blue K20]

Originally Posted by Big-Blue

This is what I need to patch. It's actually a little over five inches tall so a 6" tall piece would give me enough to trim and fit.

I worked 7:00am to 12:00am yesterday so I didnt have a chance to look but I believe I have it. Just need to make sure it's not all dented. I'll let you know tomorrow.

[Ol Blue K20]

No problem, would you prefer the cuts on the tops or the valley of the bed? Also send me the shipping address and I will let you know the total shipped cost after I weigh it I figure $20.00 plus the shipping. Fair enough?

[Big-Blue]

PM sent

[Ol Blue K20]

Jon, sent a pm so i'm trying to contact you before you send money so go to pm.
Posted via Mobile Device

[TBONE1964]

Hey Old Blue,

Do you have any of the bed floor left?

I need the very end piece near the tail gate. About 12 inches from the end on both sides. Actually if you have a 12 inch square piece from the left andf right sides, that would be good.

Let me know. I will buy them if they are solid. I wont be back to Mich until next Saturday but if you can hold them, I will PM you when I get back.

Thank you.

[Big-Blue]

Ol Blue just advised his bed was full of bondo so I am still looking. Probably headed to salvage yard this weekend. Are 73 and up the same in terms of flutes in the bed to 67-72 beds?
Posted via Mobile Device