|
|
|
06-22-2011, 07:31 PM
|
#1 |
|
Registered User
Join Date: Jun 2011
Location: Eagle mountain, Utah
Posts: 7
|
3/4 inch body drop
so My question is If i bolted the bedsides of my 72 shortbed sraight to the cross sills and put the wood on top and took 3/4 inch out of the cab mouts would this work
|
|
|
|
06-22-2011, 08:51 PM
|
#2 |
|
Registered User
Join Date: Feb 2010
Location: Moyie Springs ID.
Posts: 160
|
Re: 3/4 inch body drop
where were u thinking of taking out the 3/4 for the cab mounts could probly work just fine with a little planing but i think u might run into a problem with the rear cross sill its notched for the wood not shorter
Last edited by 1low; 06-22-2011 at 08:55 PM. |
|
|
|
|
06-23-2011, 07:21 AM
|
#3 |
|
Special Order
  
Join Date: Nov 2004
Location: Mt Airy, MD
Posts: 85,852
|
Re: 3/4 inch body drop
You'd do all this for a mere 3/4"? Anything you do to the body mounts will affect their function. Is it really worth that?
__________________
"BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed" GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project) GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling) Tim "Don't call me a redneck. I'm a rough cut country gentleman" R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~ |
|
|
|
|
06-23-2011, 10:47 AM
|
#4 |
|
Registered User
Join Date: Dec 2007
Location: Mountain Home, AR
Posts: 405
|
Re: 3/4 inch body drop
No body drop is simple, they are alot of work. Just taking 3/4 inch out of the body bushing is definately not advised, as well as it will not fix your bumper mounts for the front and rear (if you are running any). If I was to do it, I would run a bolt in body drop kit by Porterbuilt. New body mounts so you can run a full size body bushings and still get your drop, has tubular crossmembers so have the most clearance, and it fixes the bumper mounting issue. You will still have to body drop the bed, but thas as simple as unbolting the floor, and moving it up the desired amount (just 3/4 of an inch if you are cutting the floor, move it more to keep a stock looking but shallow bed, you will just have to fabricate spacers, no biggie). It will get the pinch weld even with the bottom of the frame, and set it all up correctly.
|
|
|
|
|
04-27-2012, 02:30 AM
|
#5 |
|
Registered User
Join Date: Apr 2012
Location: Mountain View,Ca
Posts: 17
|
Re: 3/4 inch body drop
Has anyone done a body drop on 69 K5?
|
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
