|
08-12-2006, 10:43 PM
|
#1 |
|
FUEL CELL GURU
Join Date: Aug 2003
Location: Mineola, Texas
Posts: 993
|
Brake rotor...
What is the thickness on disc brake rotors of the 71-72 variety??? I bought some loaded calipers here a while back and they won't slip over the rotors. The rotors I have are about 1 1/4", the opening between the brake pads are about 1 1/16". Do I have the wrong calipers?? Later, Mark
|
|
|
|
08-12-2006, 10:46 PM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Brake rotor...
take a c-clamp and try pushing the piston all the way into the bore to get the clearance needed
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
08-13-2006, 11:17 AM
|
#3 |
|
FUEL CELL GURU
Join Date: Aug 2003
Location: Mineola, Texas
Posts: 993
|
Re: Brake rotor...
The loaded calipers are brand new and already bottomed out. I am thinking that maybe these calipers fit GM cars.
Last edited by FuelCellGuy; 08-13-2006 at 11:17 AM. |
|
|
|
|
08-13-2006, 11:33 AM
|
#4 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
Re: Brake rotor...
Early 80's pickups (some) had a 1" thick rotor, vs the 1 1/4" rotors on the older trucks. These required different spindles, as well as calipers.....
 L
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
