Drilling fenders for side moldings - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**nitrosport_5** · 08-26-2012, 09:17 PM

I bought a pair of used chevy fenders to put on "rusty", but they came without pre-drilled holes for the side moldings. The emblem holes are there as well as the holes for the "8-350" callout. what is a good way to drill the holes in the correct spot. can it be done with the fenders off of the truck? be nice to get them drilled before i have everything painted.

Sorry if this has been brought up before. I tried searching a few different keywords but i just didnt come up with anything that i felt was useful for me. Thanks

08-26-2012, 09:17 PM	#1
nitrosport_5 Registered User Join Date: Jul 2012 Location: St. John, Washington Posts: 618	Drilling fenders for side moldings I bought a pair of used chevy fenders to put on "rusty", but they came without pre-drilled holes for the side moldings. The emblem holes are there as well as the holes for the "8-350" callout. what is a good way to drill the holes in the correct spot. can it be done with the fenders off of the truck? be nice to get them drilled before i have everything painted. Sorry if this has been brought up before. I tried searching a few different keywords but i just didnt come up with anything that i felt was useful for me. Thanks __________________ "Rusty" 1972 K20 Cheyenne Super, 496, A/C, Tilt, Tach, Buckets, 4l80e/NP205, 4" Rancho Lift, 35" BFG AT "Ramp Truck" 1972 C30 Ramp Truck 350, Air Bags, Factory A/C. "1968" C10 Shortbed project

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.