|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-11-2019, 04:24 PM
|
#1 |
|
Senior Member
 Join Date: Sep 2017
Location: Bryan, Texas
Posts: 2,379
|
Specialty Power Window kit
Got my Specialty Power Window kit test fit in the door. I wanted to see what had to be done so I could do any patches or repair after it was test fit.
It went in ok, but there is a bolt head that sits on the inside of the door about 10" down from the bottom of the window, when rolled up. Has anyone installed this kit, and if so, what did you do to camoflauge that bolt in the middle of the door? Thanks.
__________________
8man-aka Robert 1948 on a S10 Frame, small block with a carb 1954 Cab, 53 Front and Bed, 50 Doors, S10 Frame, Power TBD Build thread: "]http://67-72chevytrucks.com/vboard/showthread.php?t=746899&highlight=wife%27s+48[/URL] [/URL]http://67-72chevytrucks.com/vboard/showthread.php?t=840204 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode