78 C10 wheel fitment feedback - The 1947 - Present Chevrolet & GMC Truck Message Board Network

miket007 · 12-07-2020, 11:13 PM

Hey Guys...I am looking to go with some old school slotted mags...the US Mags indy...15X9 on the front and 15X10 in the rear....78 C10 2wd Big ten. The 15X9 shows a -12 offset 4.5 backspacing...test fitting one, I find the outer part of the tie rod end at the knuckle just barely touches the inside of the wheel...it is so slight that I would think you could kiss the rod end with a grinder and it would clear.

Anyone have experience using the 15X9 4.50 on the front, 15X10 3.50 on the back?

12-07-2020, 11:13 PM	#1
miket007 Registered User Join Date: Apr 2015 Location: Phoeniz, az Posts: 5	78 C10 wheel fitment feedback Hey Guys...I am looking to go with some old school slotted mags...the US Mags indy...15X9 on the front and 15X10 in the rear....78 C10 2wd Big ten. The 15X9 shows a -12 offset 4.5 backspacing...test fitting one, I find the outer part of the tie rod end at the knuckle just barely touches the inside of the wheel...it is so slight that I would think you could kiss the rod end with a grinder and it would clear. Anyone have experience using the 15X9 4.50 on the front, 15X10 3.50 on the back? __________________ 78 C-10 Silverado Big Ten A/C, PS/B, Tilt, GM 350HO/T350, 12 bolt posi, Two-Tone full length Headers, Lowered with factory ralleys, 2.5" duals with Dynomax 17749's 69 Caprice 2d Custom Coupe 427

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.