Axels & Steel Beds - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Locked · 12-25-2005, 12:32 AM

I need a lower ratio rear end instead of the stump puller on my 67 C-20; also
Are there any sources for complete steel beds for 67-72 C-20 long boxes?

On the rear end, it drives on the highway, like it's in 2nd gear, while in 3rd. Anything over 40 mph sounds like it's overreving!

I have searched through many parts suppliers on line for sheetmetal parts but only can find small repair panels for the bed floor. Mine has rust at the ends where it is rolled.

Project location is Spokane, Washington.

12-25-2005, 12:32 AM	#1
Locked Member Join Date: Mar 2005 Location: Spokane, WA Posts: 14	Axels & Steel Beds I need a lower ratio rear end instead of the stump puller on my 67 C-20; also Are there any sources for complete steel beds for 67-72 C-20 long boxes? On the rear end, it drives on the highway, like it's in 2nd gear, while in 3rd. Anything over 40 mph sounds like it's overreving! I have searched through many parts suppliers on line for sheetmetal parts but only can find small repair panels for the bed floor. Mine has rust at the ends where it is rolled. Project location is Spokane, Washington. Last edited by Locked; 12-26-2005 at 03:51 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.