New exhaust w/6" drop pics

[see ten]

I have seen requests for pictures and info for this several times so I thought I would put up a couple pictures. The exhaust is 2.25" aluminumized tubing. I used the ECE trailing arm crossmember (thought I took a pic of the pipe running through it but apparently not). The pipe goes over the trans crossmember and through the trailing arm crossmember. I also had a balance tube installed. I asked about a X pipe but he just didn't think he could make it happen and remain above the height of the framerails. Here are a couple shots from the side just to show that nothing is below the framerails.



Here's the balance tube.


I had him stay outside of the rails after the axle in case I ever want to go back and add a rear fuel tank.


The driver's side was tight! We had to take the bolt out of the track bar and turn it around (face the head towards the front of the truck) in order to make room for the pipe.



The passenger side wasn't near as bad.



And of course the tips!