Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
11-26-2006, 11:30 PM | #1 |
Registered User
Join Date: May 2006
Location: San Antonio, Texas
Posts: 372
|
Here's my rust situation....(CAUTION..OOGLY!)
I'm gonna need new front and rear floor sections, new inner and outer rockers, new cab floor supports and new kick panels. I have everything but the kick panels. The rocker boxes look fine....they'll need some sanding and a coating though. I keep putting it off dreading the day that I start. It's just hard to know when and where to start. My idea of working on it so far is to get all geared up, open the hood...stare at it for a while....then open the doors and stare at the floors for a while....then grab a beer, put my hands on my hips, shake my head and go back inside. I started to cut out some of the rust. Do you guys see any place where I'm gonna have some trouble? One place that *I* am concerned about is the little hump that the seat sits on. There's a good bit of rust on it and as far as I know, they don't make that piece.
__________________
'72 K5 CST Blazer 4x4 in perpetual progress '96 2dr Tahoe 4x4 daily driver, Black Bear Performance tune, 285-75-16 Nitto Grapplers, Magnaflow muffler, K&N Air filter, Bilstein Shocks.........E-fan, DT Tri Y or Pacesetter LTs coming soon Last edited by Blizz; 11-26-2006 at 11:35 PM. |
Bookmarks |
|
|