|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-31-2006, 10:40 PM
|
#1 |
|
Retrofit Management
Join Date: Apr 2006
Location: Las Vegas, NV
Posts: 73
|
Temp control panel mounting
Happy New Year all. I'm spending this evening in the garage and have run into a smalll problem on my 65. I'm upgrading my temp control from single knob to the 3 lever setup in conjunction with a package A/C install and I can't figure out how the bottom of the panel is supposed to secure to the dash. There are two holes in the top of the panel and two matching points in the dash to receive the scews but the bottom has no attach points. Am I missing some parts here? The panel I got from Ebay has what looks like partial hole in the bottom but there is not a matching attach point in the dash....
 Anybody done one of these an can offer some assistance? TIA 
__________________
My retrofit fleet -1966 Suburban 2002 Tahoe drivetrain, firewall, floor, chassis and interior in progress -1965 C-10 shortbed stepside, 2003 5.3/4L60E conversion. Power steering, tilt wheel, power front disc brakes, 2.5/4 inch drop, relocated fuel tank and battery, 2002 Silverado buckets and console. Swap Pics -1968 Camaro 95 LT1/4L60E lots o' mods Web Page -1961 Corvette project Corvette Corrections frame, C-4 suspension and brakes, 02 LS1/T-56, Never ending body workPics |
|
|
| Bookmarks |
|
|
Threaded Mode