Stepside fenders on a fleetside bed? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Als454 · 08-13-2007, 08:06 PM

I have a 1972 C30 "Dually" with a fleetside bed on it. I need to extend the fenders about 5" on either side to cover the rear wheels. I have a set of fiberglass stepside fenders that I want to cut to fit. I have seen this done before on these trucks. My question is to anyone who has done this is how do I cut them to match the profile of the fleetside bed. This is even more complicated as the profile of the bedsides change from one end to the other. Is there an easy way to do this.
Allen

08-13-2007, 08:06 PM	#1
Als454 Senior Member Join Date: Jan 2002 Location: Vienna, Ohio, USA Posts: 259	Stepside fenders on a fleetside bed? I have a 1972 C30 "Dually" with a fleetside bed on it. I need to extend the fenders about 5" on either side to cover the rear wheels. I have a set of fiberglass stepside fenders that I want to cut to fit. I have seen this done before on these trucks. My question is to anyone who has done this is how do I cut them to match the profile of the fleetside bed. This is even more complicated as the profile of the bedsides change from one end to the other. Is there an easy way to do this. Allen __________________ 72 Chevy A/C P/B P/S Tilt 454 Engine 400 TCI Trans C30 Frame C10 Suspension Short Wheel Base (Dually)



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.