advance curve kit bushings - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Alex Hayley · 09-22-2007, 10:11 PM

I purchased a Mr Gasket HEI Advance Curve Kit #929 to rebush and spring my distributor. The kit comes with two types of bushings: a simple cylinder and a cylinder with a base on it. The simple cylinder bushing fits on the distributor weight pins with a lot of play, not "snug" as the instructions state. The cylinder with a base bushing does not fit on the distributor weight pin at all. I can push on the bushing as hard as I feel comfortable and it will not go on. In addition, the bushings are too large for the holes in the stock weights. Do I have the incorrect kit or is there a trick to this?

09-22-2007, 10:11 PM	#1
Alex Hayley Registered User Join Date: Jul 2000 Location: NC Posts: 987	advance curve kit bushings I purchased a Mr Gasket HEI Advance Curve Kit #929 to rebush and spring my distributor. The kit comes with two types of bushings: a simple cylinder and a cylinder with a base on it. The simple cylinder bushing fits on the distributor weight pins with a lot of play, not "snug" as the instructions state. The cylinder with a base bushing does not fit on the distributor weight pin at all. I can push on the bushing as hard as I feel comfortable and it will not go on. In addition, the bushings are too large for the holes in the stock weights. Do I have the incorrect kit or is there a trick to this?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.