C-Notch Questions and Opinions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

muthstryker · 10-18-2010, 09:14 PM

Im thinking about possibly going with the CPP Trailing Arm Conversion kit for my truck, Well I already have a c-notch installed. The CPP kit comes with a notch that has the spring mounts on it so it has to be used with the kit. The c-notch bolt holes are different then the bolt holes on mine, but I was wondering if I would have a problem if I was to take mine off and put the other one on and just drill the holes for it. Or would it make the rear of my truck weak seeing how it would almost be like swiss cheese on that section of the frame?

Looking for opinions and/or ideas, Maybe I could weld a plate on the inside of the frame and drill through that, stiffening up that area?

10-18-2010, 09:14 PM	#1
muthstryker Registered User Join Date: Dec 2009 Location: Snohomish, Washington Posts: 1,187	C-Notch Questions and Opinions Im thinking about possibly going with the CPP Trailing Arm Conversion kit for my truck, Well I already have a c-notch installed. The CPP kit comes with a notch that has the spring mounts on it so it has to be used with the kit. The c-notch bolt holes are different then the bolt holes on mine, but I was wondering if I would have a problem if I was to take mine off and put the other one on and just drill the holes for it. Or would it make the rear of my truck weak seeing how it would almost be like swiss cheese on that section of the frame? Looking for opinions and/or ideas, Maybe I could weld a plate on the inside of the frame and drill through that, stiffening up that area? Last edited by muthstryker; 10-18-2010 at 09:15 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.