Ride Tech C10 Strong Arm Question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

SCOTI · 11-25-2010, 05:18 PM

Ok here's a goofy one.... When installing the Ride Tech front C10 Strong Arms (1st series of arms), does it matter what the top/bottom orientation of the arms are? If you look @ them, they can be flipped either way & will work on either side. I'm just wondering if one way is correct/better?

The BJ flange would either be slightly above or below the a-arm tube depending on how they're installed. I never really gave it much thought before & as I was prepping everything for the 64, I started wondering if anyone else thought about it.....

11-25-2010, 05:18 PM	#1
SCOTI Registered User Join Date: Apr 2001 Location: DALLAS,TX Posts: 22,144	Ride Tech C10 Strong Arm Question Ok here's a goofy one.... When installing the Ride Tech front C10 Strong Arms (1st series of arms), does it matter what the top/bottom orientation of the arms are? If you look @ them, they can be flipped either way & will work on either side. I'm just wondering if one way is correct/better? The BJ flange would either be slightly above or below the a-arm tube depending on how they're installed. I never really gave it much thought before & as I was prepping everything for the 64, I started wondering if anyone else thought about it..... __________________ 67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... *Cubic inches is like Indiana Jones with a cheap pistol.*



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.