![]() |
![]() |
#11 | |
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,967
|
Re: Project: Recycle
Quote:
Originally, they're manufactured w/the bushings press fit to the stud (which was press/interference fit to the shock). The original rubber bushing ID was .500"; the stud OD was .625". The fit was so freakin' tight it basically compressed the bushing (increasing the density/area). Unfortunately, there was no way to tighten them down in that configuration w/my Porterbuilt rear shock brackets. The shock studs need to be installed & torqued to spec, then the shock can be installed onto the stud. These bushings are Prothane brand (polyurethane). The sleeve wouldn't be any different vs. the solid .625" stud/shank they're riding on & I tightened the hardware to the limit of the shank (the shank prevents over tightening of the bushings).
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
![]() |
![]() |
Bookmarks |
|
|