Replacing gas tank sending unit HELP - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Jkeith · 11-21-2011, 10:42 PM

I pulled the tank out of my truck so I could replace the cab corners. I poured the gas out of the tank while I had it out cause there was a bottle lid in it. The gauge was fine when I pulled the tank and when I put it back in its stuck on full. When I ground the wire it goes to e so I believe the float is stuck. But I don't know how to pull the unit out. It has no bolts. Any help we be greatly appreciated.
Posted via Mobile Device

11-21-2011, 10:42 PM	#1
Jkeith Registered User Join Date: Oct 2011 Location: Nancy, KY Posts: 154	Replacing gas tank sending unit HELP I pulled the tank out of my truck so I could replace the cab corners. I poured the gas out of the tank while I had it out cause there was a bottle lid in it. The gauge was fine when I pulled the tank and when I put it back in its stuck on full. When I ground the wire it goes to e so I believe the float is stuck. But I don't know how to pull the unit out. It has no bolts. Any help we be greatly appreciated. Posted via Mobile Device



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.