![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
![]() Join Date: Jul 2012
Location: St. John, Washington
Posts: 618
|
Drill Front Fender Upper/Lower Moldings
Is there a good way to go about drilling fender moldings without the fender on a truck? was going to paint my parts before installing them. My 2 replacement fenders have no moldings on them. I looked through the asembly manual and the measurements they give look like they are from the top of the hood. Really wasnt planing on installing the fenders until they were painted, and wnated to get the holes drilled and out of the way. Less risk of screwing up fresh paint. The rest of the truck already has the modling holes, just not the 2 front fenders i picked up.
__________________
"Rusty" 1972 K20 Cheyenne Super, 496, A/C, Tilt, Tach, Buckets, 4l80e/NP205, 4" Rancho Lift, 35" BFG AT "Ramp Truck" 1972 C30 Ramp Truck 350, Air Bags, Factory A/C. "1968" C10 Shortbed project |
![]() |
![]() |
Bookmarks |
|
|