|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-12-2021, 10:14 PM
|
#1 |
|
Registered User
Join Date: Feb 2018
Location: Doland SD
Posts: 836
|
Made a custom tool for or silverado t case
My encoder motor whent bad on me at work. I was stuck in 4 low. Home is 50 miles away. So during lunch brake I took the motor off so see what I could do. O'rileys wanted $350 for one. A guy just couldn't swing that right now so I needed a way to shift it manually with out damaging the splines on the t case. So I took the motor apart and got the peace that goes to the t case out. It has a gear on it. The gear broke in half when trying to press it out. Any way now I have a perfect fit for the splines. But no good way to grab it. So I found an old garbage socket from work and welded the socket to the female splins . Not only did it work perfectly I can use it again to aline the new motor when I get. Dont judge my welds I was welding blind.
__________________
 ( second times the charm) 71 gmc c15 307 sbc 373 rear gears positrac sm 465 trans. ( not listed on spid but is original )94 chevy k1500 350 tbi 373 rear gears 4l60e one wheel peel. Gutless 07 gmc sierra classic rcsb 4.3 lt 5 speed w/t 04 chevy Silverado 1500 ext cab 5.3 4l60e. 81 chevy Scottsdale k10 muncie sm465 Np208 10 bolt 8.2 ( Old Green) |
|
|
| Bookmarks |
|
|
Threaded Mode