|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-15-2025, 08:32 PM
|
#1 |
|
New Member
 Join Date: Sep 2020
Location: Santa Barbara CA
Posts: 2
|
Stubborn series 56 connector
Pretty basic stuff here, but HELP! Installing new M and H dash harness, all going smoothly but can't open the connector at the firewall between the existing (old) dash harness and the (old) engine harness. Presume it's a typical series 56 male/female (four wire) connector. Well lubricated..?need special tool to release? Would rather not pull the whole rubber grommet through the firewall. Any advice appreciated.
|
|
|
| Bookmarks |
|
|
Threaded Mode