|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-16-2004, 10:03 PM
|
#1 |
|
Next project: 1970 K10
Join Date: Feb 2004
Location: Fort Collins, Colo 80524
Posts: 6,685
|
One solution for low hanging exhaust
I just couldn't leave well enough alone!! I was ready to pull the frame outside to degrease before taking to the sandblasters, and thought I would try to do something about the low hanging exhaust problem.
I want this truck to sit lower than it did before getting munched. But, the way the exhaust had to pass under the middle crossmember (the one the carrier bearing mounts in), I didn't want to go much lower. So, here is what I did. I think it should work OK. Material is 1/4" mild steel.  
__________________
Bob 1970 Chevy K10 LWB "Goldie" 350/TH350 next project!! 1981 Chevy C10 LWB 355/TH350 - My son's truck LS SWAP FORUM! Tons of LS swap info here! PLEASE CLICK HERE TO SUPPORT THE GREATEST BOARD ON THE NET! CLICK HERE FOR THE FAQ INDEX by KRUE |
|
|
| Bookmarks |
|
|
Threaded Mode