![]() |
![]() |
#1 |
Registered User
Join Date: Dec 2011
Location: New York City
Posts: 648
|
I6 throttle
Does anyone know how to get this pin out of the manifold? I thought as soon as I took the cotter pin off the side of the throttle mechanism the whole thing would slide out. I've tried whacking it and that does absolutely nothing.
I want to swap from the rod throttle assembly to the cable version. I got the proper brackets from a board member , which use a bolt instead of this "pin", and attach from the other side. |
![]() |
![]() |
![]() |
#2 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: I6 throttle
It's just seized. It should tap out like you're thinking. You might have to get medieval on it.
Posted via Mobile Device |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Dec 2011
Location: New York City
Posts: 648
|
Re: I6 throttle
Ahh, cool. I thought so. Thank you, sir. BFH it is!
Posted via Mobile Device |
![]() |
![]() |
![]() |
#4 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: I6 throttle
Just don't mushroom it or you'll never get it out of there. Maybe use a brass punch if you have one.
Posted via Mobile Device |
![]() |
![]() |
![]() |
#5 |
Registered User
![]() Join Date: May 2011
Location: Long Island NY
Posts: 787
|
Re: I6 throttle
drill it
|
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: Dec 2011
Location: New York City
Posts: 648
|
Re: I6 throttle
"Check", on the brass punch. I've seen mushrooming done by an over-eager gorilla or two in the past.
Drilling might be next. Someone told me to heat the manifold and apply cold to the pin. Torch for the manifold, but what for the cold? Ice cubes? I'm not taking my motor apart to stick this in the freezer! |
![]() |
![]() |
![]() |
#7 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: I6 throttle
If you'll heat that raised lump where the pin sits, I'd about bet it will come out with hammer and punch. Heat does wonders. You'd be hard pressed to apply any appreciable amount of cold to it.
Posted via Mobile Device |
![]() |
![]() |
![]() |
#8 |
Registered User
Join Date: Mar 2004
Location: Hoytsville, Utah
Posts: 3,365
|
Re: I6 throttle
A good source of cold are those spray-air cans that you use on your keypads. Turn them upside down so the fluid comes out and it's really cold. It'll knock the bottom out of a thermometer!
![]()
__________________
'68 Panel Project Boogie Chillin' '68 C-10 Ol' Green |
![]() |
![]() |
![]() |
#9 |
Registered User
Join Date: Dec 2011
Location: New York City
Posts: 648
|
Re: I6 throttle
Got those too.
![]() |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|