Is this taped trim molding available?

[wazzabie]

Is this taped trim molding available as a reproduction part?

[Getter-Done]

https://www.usa1industries.com/1981-...g-set-longbed/

[Keith Seymore]

Originally Posted by Getter-Done

https://www.usa1industries.com/1981-...g-set-longbed/

Since there is no photo, how does one know it is not this molding?

(especially since they show the chrome corner molding right next to it?)

K

[Getter-Done]

Originally Posted by Keith Seymore

Since there is no photo, how does one know it is not this molding?

(especially since they show the chrome corner molding right next to it?)

K

Very good point.

I Click and saved the wrong link.
This is late model Square Body trim.



They defiantly need a photo.

[Getter-Done]

How about this?

Link: https://www.walmart.com/ip/Black-Sid...erId=101001238

[wazzabie]

Originally Posted by Getter-Done

How about this?

Link: https://www.walmart.com/ip/Black-Sid...erId=101001238

It looks like this molding however the original is less then 2in in width. This item is 2.25in in length. I guess I need to see a sample of it. Maybe the extra width is not much of an issue.

[Getter-Done]

Originally Posted by wazzabie

It looks like this molding however the original is less then 2in in width. This item is 2.25in in length. I guess I need to see a sample of it. Maybe the extra width is not much of an issue.

This was a Question I had for you and did not Type.

I did not know the width of your trim.

The point of the front point is the main issue.

It would maybe blend in, if you cut it carefully.

That would only be an 1/8 inch difference each side.

So, if the original point of trim was cut at an angle.

Of course, the angle would be cut (Taking wind in Consideration).

Just a thought.