|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-25-2006, 09:27 AM
|
#26 |
|
Junk/Daily Driver Club
 
Join Date: Feb 2004
Location: Manheim, PA 17545
Posts: 253
|
Re: Another Stupid 4x4 Question - Front Spindle 3/4 vs. 1/2???
The Dana 44 front axle in your thuck should have 3.07 gears. That was standard with a "71" K-10 350 motor truck. To match them gears use a Dana 61 rear,they come in semi or full float. I got one out in the garage that I`m putting under a "72" K-10 chassis to 8 lug and match the 3.07 gears in the front.
Good luck! Later Willis
__________________
Daily Driver: 1970 C-20 400 sbc,sm-465,Dana 61 one ton SRW rear, 3.07 gears, locker.  There are three kinds of people: those who make things happen, those who watch things happen, and those who have no idea what happened! Last edited by 67-72williso; 11-25-2006 at 07:26 PM. |
|
|
|
12-03-2006, 08:42 PM
|
#27 |
|
Registered User
Join Date: Jul 2006
Location: Central PA
Posts: 12,201
|
Re: Another Stupid 4x4 Question - Front Spindle 3/4 vs. 1/2???
I have a set of Dana 44 3/4 ton hubs that I will sell you, they should bolt right up and give you 8 lugs, all you should need is the backing plate, rotors, calipers and pads... let me know.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
