new center console

[justpball]

Originally Posted by blu-by-u-2

I was wondering the same on the 4x4. I was also wondering about the taillights on the badass slammed one. I don't see the trim ring around them. OH yeah "praise the lowered"

the tails are the ebay euro lights and then we smoked them.

[rodtruckdesign]

Originally Posted by rodtruckdesign

the sides look like 1/2 or 3/4 inch plywood......now for the top....you can get kerfed plywood....i have forgotten the brand name...check at woodworker supply businesses.....about a 1/4 in thick....it will bend in that contour....it only bends in one direction....but with a console like Justpball's it only bends in on direction so that stuff would work..... cut sides to shape....staple or nail bending plywood to the sides..... then lay up fiberglass over the 1/4 in material.....bondo prime and paint to match.....there you have it...i hope this helps

quick addition....the price of the 3/8 bendable plywood is around 45.00 dollars a sheet.....you can get it where it bends in the 8 foot direction or the 4 foot direction....this is from wurth products in the charlotte nc area....i feel sure you can find it closer to home....there's all the news that's fit for print...have a nice day!

[Captkaos]

Nice Job!

[texasfunk]

man looks good bro!!! im def going to make one!!!

[MI2CHEVYS]

Originally Posted by rodtruckdesign

quick addition....the price of the 3/8 bendable plywood is around 45.00 dollars a sheet.....you can get it where it bends in the 8 foot direction or the 4 foot direction....this is from wurth products in the charlotte nc area....i feel sure you can find it closer to home....there's all the news that's fit for print...have a nice day!

you could also use wood veneers they are usually less than a 1/4 inch thick and are very bendable. If you buy a pine veneer it will most likely be cheaper than lets say oak or maple.