![]() |
![]() |
#1 |
Registered User
Join Date: Sep 2000
Location: huntington,texas,united states
Posts: 399
|
door hinges
ok guys ive got a question. im trying to get my hinge pins out of my door hinges so i can install new ones but im having a hard time trying to knock them out. is there an easy way in doing this. i ground the pointed end off flush with the rest of the hinge but still no movement in the pin when i hit it. any help would be appreciated
__________________
1972 chevy long bed. Currently under construction!! Bagged, 383/700r4. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Apr 2004
Location: Clanton, AL
Posts: 1,253
|
I can sum it up in one word...Pneumatics. Buy yourself a cheap (or good) air hammer/chisel & they usually come w/ a few chisels.
Hit it w/ that & be patient. It'll just sit there hammering, hammering, hammering, & then all of a sudden it starts to move. WD-40 & about 2-3 days time helps too. You'll need another small rod (like a center punch for driving finishing nails flush) b/c the chisel will be too bid to chase the hinge pin the entire way.
__________________
85' CUCV M1009!!! The newest addition! 6.2diesel, Th400, NP208, & only 36k miles! 70' C-10 LWB Fleetside - Looking good these days! ![]() 05' Dodge Neon 88' Winner Escape Sport 1750 - 4.3v6 94' Seadoo SP 84' Honda TRX200, bare nekkid. Just a frame & tires. Always looking for another project or any good deal! ![]() |
![]() |
![]() |
![]() |
#3 |
Sisyphus was my mentor!
![]() Join Date: Sep 2002
Location: Carleton Place, Ontario CANADA
Posts: 984
|
when I did mine I had to beat the krap outa them with a 5lb hammer. I added heat from a propane torch & that made them go easier.
__________________
passthebuck ![]() #5642 -TWO 1967 GMC 910's. One with L6/3-on-the tree and the other with 355 w/435hp & a 700r4. -a 2013 Honda Civic as my "sensible" car |
![]() |
![]() |
![]() |
#4 |
Registered User
![]() Join Date: Apr 2004
Location: The Other Maine!
Posts: 2,236
|
Good advice, heat is our friend!!!!! Also sound advice penetrating oil and some time.
I found Kroil works better than wd-40. As I am a farmer I deal with rust on equipment all the time. Good luck with hinge repair, Mike |
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Dec 1999
Location: BRADENTON FLA
Posts: 3,269
|
We put them in a vise and heat them with a torch and knock the pins out with a long carriage bolt.
__________________
Rest in Peace Ed. Thanks for all the good times. |
![]() |
![]() |
![]() |
#6 |
TOTY 2006
![]() Join Date: Dec 1999
Location: Magalia CA USA
Posts: 2,270
|
I had to use a press to get my pins out. Tried using a hammer and punch, just broke the punch....
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|