|
03-12-2003, 12:28 PM
|
#1 |
|
Registered User
Join Date: Dec 2002
Location: wisconsin
Posts: 75
|
ID transfer case??
how do i ID my transfer case i have.. i got it out of 78 3/4 ton truck automatic.. i am putting it in a 72 chevy with a four speed is this going to work?? i need help new to all of this stuff.
|
|
|
|
03-12-2003, 01:10 PM
|
#2 |
|
Registered User
Join Date: Mar 2003
Location: Oregon
Posts: 229
|
Here is one web site that may help. You have to have Adobe Acrobat Reader to look at it.
http://www.advanceadapters.com/acrobat/gm.pdf Bottom line if its a NP205 transfer case it will have a silver dollor sized cover on the backside with three bolts holding it on. Bill |
|
|
|
|
03-13-2003, 08:53 AM
|
#3 |
|
user # 2756
 
Join Date: Jun 2001
Location: Chesapeake, Virginia
Posts: 4,612
|
NP205 input shafts are different depending on which tranny they were mated to.
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs 1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX 1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears 1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now..... 1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone. 1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed. 1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm 
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
