|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-11-2019, 02:24 PM
|
#1 |
|
Registered User
Join Date: Jan 2017
Location: Larkspur, Colorado
Posts: 916
|
Source or part# 69 C20 HO52 5 bolt pinion flange gasket?
Resealing the HO52 in my 69 CST20. Not finding a gasket for the pinion flange anywhere. Thought I would be able to just use RTV, not possible, the mating surfaces will not come together the way the flange is machined without a gasket. I’ll just buy some gasket material and make my own if one is not available. Thought I would give this a shot to see if any of you might know of a source and part number for that gasket.
Steve weim55 Colorado |
|
|
|
11-11-2019, 07:21 PM
|
#2 |
|
Senior Member
 
Join Date: Aug 2018
Location: Western Colorado
Posts: 1,165
|
Re: Source or part# 69 C20 HO52 5 bolt pinion flange gasket?
Nothing wrong with making one. That's what I had to do for my axle flange/brake backing plate gaskets on my Dana 44 rear end.
__________________
1964 Chevy C10 - Gen IV 5.3 Restomod http://67-72chevytrucks.com/vboard/s...d.php?t=768632 1968 GMC C15 - Gen III 6.0 Restomod http://67-72chevytrucks.com/vboard/s...d.php?t=772047 1969 Chevy C10 - Restoration http://67-72chevytrucks.com/vboard/s...d.php?t=809184 1978 Chevy Scottsdale K20 1993 Chevy C1500 - 5.3/T56 swapped 2008 Silverado Duramax |
|
|
|
|
11-11-2019, 11:49 PM
|
#3 |
|
Registered User
Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,229
|
Re: Source or part# 69 C20 HO52 5 bolt pinion flange gasket?
It will take some extra thick gasket material. The gasket has to fill in the gap between the flange & housing. The original is a thick cork gasket.
George |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
