|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-28-2004, 03:56 PM
|
#1 |
|
Senior Member
Join Date: Sep 2004
Location: CANADA
Posts: 1,681
|
clutch linkage question
I changed the engine in my 72 1-ton to and 84 350 block.the two holes in the block that the pivot ball mounts to are not on the 84 block. any ideas on how to mount it?
|
|
|
|
11-28-2004, 03:59 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
No answer here, just find it interesting that the holes aren't there...my last two small blocks were from 86 and 87, and they both had the holes there.
|
|
|
|
|
11-28-2004, 04:02 PM
|
#3 |
|
Watch out for your cornhole !
 
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
I've run into this before.
There should be bosses where the holes are supposed to be. Drill and tap the holes into the blank bosses. It's cast iron, it taps super easy.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
|
11-28-2004, 04:29 PM
|
#4 |
|
Registered User
Join Date: Mar 2003
Location: Bremerton, WA
Posts: 1,839
|
Dubie didn't have the tapped boss either. He made a bracket. Ask him for the pics.
__________________
Silence is golden, duct tape is silver. - Scott |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
