Is this the correct exhaust manifold?

[1972]

Hey guys, I'm new to the 67-72 trucks and don't know squat about them, but now I need to learn. Is this pic of a factory passenger side exhaust manifold or has it been swapped out? It looks different than the driver side manifold.

[68CST327]

Looks like it's been swapped out. Both sides should match, and they dump in the center, not at the end. They resemble a ram's horns, hence the name, "ram's horn exhaust manifold."

Should look like this:

[1972]

Ok, thanks. I was looking at a pre-bent exhaust system in a catalog and something just didn't look right. Thanks for the quick reply.

[Rod]

The pic of the manifold above is for cars typically....truck manifolds for 2wd trucks are ram horns with a turned back end. I'll post a pic of typical 72 2wd type. Striaght down ram horns are used a 4x4's.

The car type above is used on motors that have alternator brackets attached to the exhaust manifold....some 67 trucks used that type manifold..but still in a truck thats 2wd is should angle back.

72 style truck 2wd pictured here.

[Hooter]

that exhaust manifold on the passenger is off a late 80s v8, if you cared

[68CST327]

Whoops, my bad, Rod is right, that's a car manifold I posted. He posted the correct truck ones. Was the only "rams horn manifold" that came up on Google Image Search, and my brain let that one slip by.

[1972]

This is what the drivers side manifold looks like, pointing straight down. The motor looks like a mis-match of parts, but has the older style accesories on the front. Damn PO...