Ran 1/4 first time today - The 1947 - Present Chevrolet & GMC Truck Message Board Network

minibike · 01-22-2005, 09:14 PM

I had a ball running the 1/4 mile today. Couldn't hook up for nothing with the open diff. The only way I could make any time was to roll out for the first 30 feet or so and then get on it gently.

1st pass...17.5 seconds, smoking the tire through 1,2,3

2nd pass...14.7 starting slow, then nailing it.

3rd pass... 15.1, smoked, got off of it and then nailed it again.

4-6th pass...between 14.72 and 14.77 rolling start

All these were done with an open differential (no posi) How much quicker do you think it would run with a posi?

arkracing · 01-22-2005, 10:06 PM

low 13's or high 12's maybe
just a rough guess

i had a blast my first time dragging a car....
a '66 AMC Rambler with a pretty beefy 350 Chevy/350 turbo and a '87 s-10 open rear with 3:55:1 gears...

in the 1/8mile i smoked the tire the whole length and still pulled 66mph and 10's - and beat a 302 mustang with slicks and a posi (saw him do a burn out) and i didn't do one cause i didn't want to ruin my brand new tires...haha !!!!! - what a relief...didn't want to get shown up by a 302 stang...i don't mind guys with F**d's - just 80's-present stangs...can't stand them

so your def. not alone in the "one-wheel-wonder" club

Stroker · 01-23-2005, 01:06 AM

Someone could probably give you a good idea if you post your splits and 1/4 trap speed?

phantom dually · 01-23-2005, 01:19 AM

Id say still in the 14 sec. area

67ChevyC10Stepside · 01-23-2005, 01:45 AM

is your motor a stock lt1? if so i would say you wont break out of 14

cableguy0 · 01-23-2005, 02:46 AM

what was your trap speed you might possibly break into the 13's with that combo if you hook up and nothing breaks

bad 71 chevy · 01-23-2005, 02:56 AM

what kind of mods do you have and what engine

minibike · 01-23-2005, 09:56 AM

I'm hoping to get in the low 14's. The LT1 is practically stock...no headers, but it does have a cleaned up intake system compared to a camaro. Shift points are set below the rev limiter, so I might could get a little more out of programming. I was using premium unleaded, so the spark retard was probably not kicking in.

Here were the other times and speed.

Time 1: 2.137
Time 2: 9.311
ET: 14.728
MPH: 89.705

01-22-2005, 09:14 PM	#1
minibike Registered User Join Date: Jun 2002 Location: Lafayette, LA Posts: 500	Ran 1/4 first time today I had a ball running the 1/4 mile today. Couldn't hook up for nothing with the open diff. The only way I could make any time was to roll out for the first 30 feet or so and then get on it gently. 1st pass...17.5 seconds, smoking the tire through 1,2,3 2nd pass...14.7 starting slow, then nailing it. 3rd pass... 15.1, smoked, got off of it and then nailed it again. 4-6th pass...between 14.72 and 14.77 rolling start All these were done with an open differential (no posi) How much quicker do you think it would run with a posi? __________________ 69 SWB LT1/4L60E www.classicplace.com

01-22-2005, 10:06 PM	#2
arkracing Weekend Warrior Join Date: Oct 2004 Location: CT Posts: 1,787	low 13's or high 12's maybe just a rough guess i had a blast my first time dragging a car.... a '66 AMC Rambler with a pretty beefy 350 Chevy/350 turbo and a '87 s-10 open rear with 3:55:1 gears... in the 1/8mile i smoked the tire the whole length and still pulled 66mph and 10's - and beat a 302 mustang with slicks and a posi (saw him do a burn out) and i didn't do one cause i didn't want to ruin my brand new tires...haha !!!!! - what a relief...didn't want to get shown up by a 302 stang...i don't mind guys with F**d's - just 80's-present stangs...can't stand them so your def. not alone in the "one-wheel-wonder" club __________________ -'07 GMC Sierra K2500HD -'66 C10 Suburban -'68/'71 K20 Service Bed Project -'69 Chevy C30 Mason Dump -'33Ford P/U 396ChevyPowered

01-23-2005, 01:06 AM	#3
Stroker Registered User Join Date: Mar 2001 Location: Moore, Ok Posts: 1,149	Someone could probably give you a good idea if you post your splits and 1/4 trap speed? __________________ 72 SWB parts and pieces Oklahoma

01-23-2005, 01:19 AM	#4
phantom dually Project92 SWB stepside Join Date: Feb 2003 Location: Louisville KY Posts: 4,792	Id say still in the 14 sec. area __________________ 92 C1500 stepside 496 Stroker Competiton Engineering Ladder bars/QA1 coilovers. Dana 60 rear with 4.10 gear and posi. Bonspeed Palisade 20x12 in rear w/335/30/20 and 20x8.5 front w/245/40/20. 5/8 drop with Belltech springs/DJM spindles/drop shocks. WWS Progress thread http://67-72chevytrucks.com/vboard/s...d.php?t=140448

01-23-2005, 01:45 AM	#5
67ChevyC10Stepside Registered User Join Date: Mar 2004 Location: Butler PA Posts: 3,032	is your motor a stock lt1? if so i would say you wont break out of 14 __________________ 67 c-10, 400 SB, TH350, 4.10 gears, Blazer tank,camaro tach, sidemarker fuel fill (soon) WTB: stepside parts, 67 front end parts, 67 small window cab. posi for 3.73 or 4.10 for 12 bolt and 10 bolt.

01-23-2005, 02:46 AM	#6
cableguy0 Senior Member Join Date: Apr 2000 Location: Delta,Pa Posts: 14,948	what was your trap speed you might possibly break into the 13's with that combo if you hook up and nothing breaks __________________ Owner of North Point Car Care in Dundalk Md. We specialize in custom exhaust on both modern and classic vehicles. We are a full service auto shop from classics to modern vehicles. Feel free to contact me with questions. I will give a 10% discount to any board member.

01-23-2005, 02:56 AM	#7
bad 71 chevy Registered User Join Date: Jun 2000 Location: Omaha NE 68122 Posts: 637	what kind of mods do you have and what engine __________________ 71 Chevy C/10 lwb 350 5 speed nv3500 3.73 rear end 2.5" Front Drop and 4" in the back Edelbrock perfomer rpm manifold Edelbrock 600 cfm carb Headmen headers

01-23-2005, 09:56 AM	#8
minibike Registered User Join Date: Jun 2002 Location: Lafayette, LA Posts: 500	I'm hoping to get in the low 14's. The LT1 is practically stock...no headers, but it does have a cleaned up intake system compared to a camaro. Shift points are set below the rev limiter, so I might could get a little more out of programming. I was using premium unleaded, so the spark retard was probably not kicking in. Here were the other times and speed. Time 1: 2.137 Time 2: 9.311 ET: 14.728 MPH: 89.705 __________________ 69 SWB LT1/4L60E www.classicplace.com



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.