|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-30-2005, 05:52 PM
|
#1 |
|
Hotwheels?
Join Date: Dec 2002
Location: Pleasant Hill, CA
Posts: 1,145
|
Drilling front X member
Ok, my bags are going in today. Im currently drilling the crap out of the front X member for the upper plates. Ive been using my drill + jack to get the dang holes done. BUT IT TAKES FOREVER. Granted it IS about 1/3" thick stuff im going through. Im using a Colbalt bit and all, any tips on how others did it?
__________________
1978 Money Pit - CUSTOM DELUXE!!!! |
|
|
|
03-30-2005, 09:22 PM
|
#2 |
|
ureckmefixit2@cox.net
Join Date: Dec 2004
Location: Mesa AZ. (Phoenix)
Posts: 1,284
|
DRILL A 1/8 INCH HOLE FIRST. DANG MY CAP LOCK IS ON. once you drill thru than go to a bigger bit. Matt
|
|
|
|
|
03-30-2005, 10:26 PM
|
#3 |
|
Hotwheels?
Join Date: Dec 2002
Location: Pleasant Hill, CA
Posts: 1,145
|
yeah, im gonna have to do that method tommorow, I killed a unibit today
 BUT I HAVE ONE SIDE BAGGED AND BOY DO I GET LIFT! I dont lay out due to the fenders though. Its quite funny lookin having one side low as hell and the other still static.
__________________
1978 Money Pit - CUSTOM DELUXE!!!! |
|
|
|
|
03-30-2005, 11:05 PM
|
#4 |
|
Until Seventy Times Seven
Join Date: Feb 2005
Location: Rocky Mountain Front Range
Posts: 1,301
|
I echo what ureckme said. Start with a smaller bit and step your way up. Use cutting fluid, too. It'll really help. (If you put too much pressure while drilling, you may damage the bits.) Good luck.
__________________
boxRODz 1983 C10 SWB Fleetside When two halves is gone, there's nuthin left. Two nothings is nuthin. That's mathematics son. You can argue with me but you can't argue with figures. Two half nothings is a whole nuthin... |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
