Alum bushings for rear trak bar - The 1947 - Present Chevrolet & GMC Truck Message Board Network

kelsfine69 · 03-31-2005, 07:42 PM

1967-72 GMC ..Anyone ever remove the rubber bushings and install aluminum ones, or is it better to go to poly from energy suspensions

Low69CST · 03-31-2005, 08:29 PM

You could make one with a lathe, but i doubt you'd notice the difference between that and poly. Poly is what i'm using by the way.

neonlarry · 03-31-2005, 09:19 PM

Save yourself the trouble, have a look at these (about half way down the page).
http://www.stockcarproducts.com/trkarm.htm

03-31-2005, 07:42 PM	#1
kelsfine69 18 Till I Die Join Date: Mar 2005 Location: Alberta, Canada Posts: 1,522	Alum bushings for rear trak bar 1967-72 GMC ..Anyone ever remove the rubber bushings and install aluminum ones, or is it better to go to poly from energy suspensions

03-31-2005, 08:29 PM	#2
Low69CST Registered User Join Date: May 2000 Location: Frankfort, Kentucky, USA Posts: 2,163	You could make one with a lathe, but i doubt you'd notice the difference between that and poly. Poly is what i'm using by the way. __________________ '69 CST Short fleetside Lowered, 400 small block, 700R4, 4 wheel disc brakes, front sway bar & rear camaro sway bar (in progress) '87 V10 4x4 Short Fleetside Quad Suspension and Dual Tanks

03-31-2005, 09:19 PM	#3
neonlarry Registered User Join Date: Feb 2002 Location: Vacaville, CA Posts: 2,746	Save yourself the trouble, have a look at these (about half way down the page). http://www.stockcarproducts.com/trkarm.htm __________________ 70 C/10 Light Red 350/TH350, HEI, Duals w/40 series Flows, 91 seat, LED taillights 99 Pontiac S/C GTP, SLP Ram Air hood, GMPP Konis & springs 95 Neon ACR, MP PCM, AFX UDP, 3.0 CAI



Register or Log In To remove these advertisements.