More progress - The 1947 - Present Chevrolet & GMC Truck Message Board Network

CPNEJR · 04-02-2005, 05:09 PM

Today I'm starting to put more stuff back on my truck. i went to napa and got 1 of 3 u-joints, rear tranny seal, some bolts and 2 of 4 exhaust reducers that i need. one side of the exhaust is in place and we have the carrier bearing bracket mounted and the u-joint on the rear shaft

jamis · 04-02-2005, 07:50 PM

good job Jr.
Replacing U-joints can be a tough job on these old trucks.
Dont forget to buff out the seal surface of that slip yoke before you replace the seal.

JimKshortstep4x4 · 04-02-2005, 07:56 PM

Progress is good!

Keep it up,

Jim

**Canadian694x4** · 04-02-2005, 08:01 PM

Keep up the great work!

billsbowtie · 04-02-2005, 10:18 PM

looking good

LUV2XCLR8 · 04-02-2005, 10:23 PM

Wootdog · 04-02-2005, 10:27 PM

It is good that the snow finally hopefully will leave you folks alone for awhile. Kerry

72shadetree · 04-02-2005, 11:39 PM

keep it up your getting there

CPNEJR · 04-03-2005, 12:04 AM

thanks guys

jamis usualy those u-joints do give us a hard time but this one was nice to us hopefully the other two will be

**Yukon Jack** · 04-03-2005, 08:44 AM

Progress is always great - keep up the good work.

SuperCheyanne72 · 04-03-2005, 04:31 PM

looking sweet!

04-02-2005, 05:09 PM	#1
CPNEJR Registered User Join Date: Sep 2003 Location: Franconia,N.H. Posts: 1,029	More progress Today I'm starting to put more stuff back on my truck. i went to napa and got 1 of 3 u-joints, rear tranny seal, some bolts and 2 of 4 exhaust reducers that i need. one side of the exhaust is in place and we have the carrier bearing bracket mounted and the u-joint on the rear shaft Attached Images __________________ (Only) Member of the CPNE Fan Club Aint that the truth 67 C-10 350 with 3-speed tranny and 308 gears swb step 82 Z28 Camaro 355 small block over 350 hp and a borg warner super t-10 (blown engine) 72 Chevy K20 Suburban (future project) 70 Chevy K20 now 68 GMC K2500 2003 Chevy 2500hd ccsb 4X4 (daily driver)

04-02-2005, 07:50 PM	#2
jamis F.A.S.T. president Join Date: Sep 2003 Location: Florida Posts: 1,883	good job Jr. Replacing U-joints can be a tough job on these old trucks. Dont forget to buff out the seal surface of that slip yoke before you replace the seal. __________________ F.A.S.T. President and Founder Fabricators for the Advancement of Sawsall Technology "A fear of the Sawsall is a sign of retarded sexual and emotional maturity." ~Sigmund Freud, "General Introduction to Psychoanalysis"

04-02-2005, 08:01 PM	#4
Canadian694x4 Born To Lose Club Join Date: Feb 2003 Location: Calgary, Alberta/Oxenden, Ontario, Great White North Posts: 13,307	Keep up the great work! __________________ Brian Smith - "Born To Lose" 1969 Chevrolet K10 LWB Fleetside - Proud Owner For 22 Yrs - 1 of 208 Built & Sold In Canada!- 283 V8/350TH/NP208, 2" All Spring Lift, 32" Good Year MT/R's. 1972 GMC K2500 Custom LWB Fleetside - Proud Owner For 3 Yrs - 1 of 571 Built & Sold In Canada! - 350 V8/SM465/NP205, 4” Rough Country Lift, 33” Interco TSL Thornbirds 2007.5 GMC Sierra SLE 2500HD 4x4 - Proud Owner For 17 Yrs- 6.6L V8 Duramax Diesel/Allison 1000, 2" Lift, 33" Mickey Thompson MTZ's. 2008 Yamaha Raptor 700r - Proud Owner For 15 Yrs - ITP Mud Lites. 2015 John Deere 1025R - Proud Owner For 8 Yrs - 24HP Diesel/H120/54D/260B/SB1154.

04-02-2005, 10:23 PM	#6
LUV2XCLR8 The LuvShack Garage Join Date: Jan 2004 Location: Maple Grove, TN (West Side) Posts: 30,468	__________________ Owner/Op: "TN Classic Transport Carriers" The Toy: "Square Vette" 72 Hybrid Blazer Toy Barn: "LuvShack" 40 x 60 x 20 Shop Tow Piggy:"Maddy" 88 Silverado 3500 Hauler: "Feathers" 14 Aluma 8218T

04-02-2005, 10:27 PM	#7
Wootdog Senior Member Join Date: Jan 2001 Location: Virginia Beach, Va, USA Posts: 1,680	Great job. It is good that the snow finally hopefully will leave you folks alone for awhile. Kerry __________________ 1967 C10 Got it back after three years Boy I sure missed Peppy 1969 Chevelle 1990 IROC Z Convertible 2002 Silverado LT

04-02-2005, 07:56 PM	#3
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	Progress is good! Keep it up, Jim

04-02-2005, 10:18 PM	#5
billsbowtie Senior Member Join Date: Feb 2003 Location: rose hill V.A. 24281 Posts: 17,997	looking good

04-02-2005, 11:39 PM	#8
72shadetree KEEP ON TRUCKING Join Date: Sep 2000 Location: martinsville va Posts: 2,563	keep it up your getting there __________________ 72 cheyenne 2wd lwb 71 k20 sons bassett va

04-03-2005, 12:04 AM	#9
CPNEJR Registered User Join Date: Sep 2003 Location: Franconia,N.H. Posts: 1,029	thanks guys jamis usualy those u-joints do give us a hard time but this one was nice to us hopefully the other two will be __________________ (Only) Member of the CPNE Fan Club Aint that the truth 67 C-10 350 with 3-speed tranny and 308 gears swb step 82 Z28 Camaro 355 small block over 350 hp and a borg warner super t-10 (blown engine) 72 Chevy K20 Suburban (future project) 70 Chevy K20 now 68 GMC K2500 2003 Chevy 2500hd ccsb 4X4 (daily driver)

04-03-2005, 08:44 AM	#10
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,686	Progress is always great - keep up the good work. __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14

04-03-2005, 04:31 PM	#11
SuperCheyanne72 #1 OU Soonerfan Join Date: Dec 2004 Location: Oklahoma Posts: 85	looking sweet!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.