|
04-19-2005, 11:46 PM
|
#1 |
|
Registered User
 Join Date: Feb 2003
Location: Staunton, Virginia
Posts: 554
|
Intake Manifold ?
I just received a stock intake from the junk yard today for my 72' sb 350. It has a tin/galvanized oil shield on the bottom. It looks like it's been beaten up pretty good. Question is: is this an oil splash shield and can I use the manifold without it?
Thanks, Scott Last edited by 72 Cheyenne K20; 04-19-2005 at 11:47 PM. |
|
|
|
04-20-2005, 12:01 AM
|
#2 |
|
Senior Member
Join Date: Apr 2000
Location: Delta,Pa
Posts: 14,948
|
yea you can use the intake without it. its only a splash shield
__________________
Owner of North Point Car Care in Dundalk Md. We specialize in custom exhaust on both modern and classic vehicles. We are a full service auto shop from classics to modern vehicles. Feel free to contact me with questions. I will give a 10% discount to any board member. |
|
|
|
|
04-20-2005, 12:44 PM
|
#3 |
|
graphic designer
Join Date: May 2004
Location: Spokane, Washington
Posts: 841
|
even if you decide to leave it, pull it off and clean underneath it. sludge sits there and burns, holds a lot of heat. it pulls off easy, then just smack the rivets back in if you decide to put it back on.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
