Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
04-18-2005, 05:57 PM | #1 |
Registered User
Join Date: Jun 2004
Location: El Lago, TX
Posts: 1,668
|
WTB: 10 bolt or 12 bolt with 3.73's in Houston area
The gears in my 76' are too high for the 700r4 that was swapped in. Also, I just noticed that the rear end is leaking a little oil around the yoke. Rather than fix it and replace the gears, I figure it would be easier and cheaper to just replace the rear end. If anyone has one, send me a pm.
Thanks Last edited by Greenlee; 04-19-2005 at 02:44 PM. |
04-18-2005, 07:34 PM | #2 | |
Registered User
Join Date: Sep 2004
Location: Elkins, West Virginia
Posts: 2,542
|
Quote:
the pinion seal is easy to fix.....cost less than $10
__________________
1987 350 TBI lowered 5/7 |
|
04-19-2005, 02:43 PM | #3 | |
Registered User
Join Date: Jun 2004
Location: El Lago, TX
Posts: 1,668
|
Quote:
|
|
04-21-2005, 12:24 PM | #4 |
Registered User
Join Date: Dec 2003
Location: Ft. Worth, TX
Posts: 86
|
I've got a set of 3.73's that have about 500 miles on them. I changed to these from the factory 3.08's, then changed transmissions that had different overdrive ratios so i promptly took them back out. I'd take $50 for them. The tail bearing and shim is still on there so the pinion depth and set up should be close. Let me know
|
Bookmarks |
|
|