![]() |
![]() |
#1 |
Registered User
Join Date: Jul 2001
Location: reno, nv
Posts: 646
|
Van Tilts
stupid question, what are van tilts worth?
![]()
__________________
70 LWB, 350/350 A/C, P/S, 3 Tone Paint (white cap, primer gray with black guide coat) |
![]() |
![]() |
![]() |
#2 |
The LuvShack Garage
Join Date: Jan 2004
Location: Maple Grove, TN (West Side)
Posts: 30,477
|
Last One I Saw On Here Was $175 (i Think)
![]()
__________________
Owner/Op: "TN Classic Transport Carriers" The Toy: "Square Vette" 72 Hybrid Blazer Toy Barn: "LuvShack" 40 x 60 x 20 Shop Tow Piggy:"Maddy" 88 Silverado 3500 Hauler: "Feathers" 14 Aluma 8218T |
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() ![]() Join Date: Jan 2005
Location: CA
Posts: 5,465
|
In my opinion it depends a lot on whether the shifter lever pin hole is worn or not. I'd say that if the pin hole is worn, it is worthless, unless you plan on using it with a floor shifter, and have the ability to remove the shifter lever attachment.
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Mar 2005
Location: Wichita, Kansas
Posts: 122
|
What year of van are you talking about? I have one out of a low mileage 83 Chevy Van with tilt and cruise, but wasn't sure if it fit our trucks or not.
Squid
__________________
'69 C10 LWB- 305, Holley 2 barrel, 700R4, 4/5 drop, dark blue primer!, cheap driver project... Back on the road... In time to sell on Ebay. ![]() |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Nov 2003
Location: Brookings, SD
Posts: 10,497
|
I have seen them go for $100 quite commonly. More if they are modified and ready to go into our trucks.
__________________
Some people are like slinkies, they aren't good for anything, but you can't help but smile when you see one tumble down the stairs. |
![]() |
![]() |
![]() |
#6 | |
The LuvShack Garage
Join Date: Jan 2004
Location: Maple Grove, TN (West Side)
Posts: 30,477
|
Quote:
![]()
__________________
Owner/Op: "TN Classic Transport Carriers" The Toy: "Square Vette" 72 Hybrid Blazer Toy Barn: "LuvShack" 40 x 60 x 20 Shop Tow Piggy:"Maddy" 88 Silverado 3500 Hauler: "Feathers" 14 Aluma 8218T |
|
![]() |
![]() |
![]() |
#7 |
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
The 83 column is too new to be an easy swap.
The columns to look for are the 72 - 81 and a hand full of early 82 vans too....basicly, any one with the key in the dash instead of the column. |
![]() |
![]() |
![]() |
#8 |
Registered User
Join Date: Jul 2001
Location: reno, nv
Posts: 646
|
the ones i've seen are without the key in the column. are they easy to rebuild? if you rebuilt them, how much do the rebuild kits cost? thanks.
__________________
70 LWB, 350/350 A/C, P/S, 3 Tone Paint (white cap, primer gray with black guide coat) |
![]() |
![]() |
![]() |
#9 |
Senior Member
Join Date: Nov 2003
Location: Brookings, SD
Posts: 10,497
|
You can get $100+ into them if you purchase the three new bearings, rubber seals (firewall and bezel), and the turn signal switch.
__________________
Some people are like slinkies, they aren't good for anything, but you can't help but smile when you see one tumble down the stairs. |
![]() |
![]() |
![]() |
Bookmarks |
|
|