another question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

82c10 · 08-23-2005, 06:48 PM

how do you use the shim kit that comes with a starter,it looks pretty close, i know its supposed to be pretty close, it comes with a rod, i have heard this is how you test it, how do you use the rod that comes with it

**Captkaos** · 08-23-2005, 07:03 PM

With the gear out there should be enough room to put a jim clip (or this rod) between the peak of the gear on the starter and the valley of a gear on the flexplate.

*1FaastC10* · 08-23-2005, 07:27 PM

i was always told that it was between the shaft that the gear slides on and the peak of the teeth on the flywheel or flexplate.

08-23-2005, 06:48 PM	#1
82c10 needin' money Join Date: May 2005 Location: Chickasha, Oklahoma Posts: 1,106	another question how do you use the shim kit that comes with a starter,it looks pretty close, i know its supposed to be pretty close, it comes with a rod, i have heard this is how you test it, how do you use the rod that comes with it __________________ *SWB Stands for Short Wide Bed*

08-23-2005, 07:03 PM	#2
Captkaos www.73-87chevytrucks.com Join Date: Dec 1999 Location: Birmingham, AL Posts: 6,935	With the gear out there should be enough room to put a jim clip (or this rod) between the peak of the gear on the starter and the valley of a gear on the flexplate. __________________ Chris Lucas 1973 Chevy C-10 1978 GMC Jimmy (2WD) - SOLD 1987 R10 twin turbo LS 1991 R3500 SRW CrewCab 1985 K5 diesel swapped project 1989 K5 2WD conversion w/ Vette susp Project Captkaos Customs 73-87chevytrucks.com

08-23-2005, 07:27 PM	#3
1FaastC10 Account Suspended Join Date: Oct 2002 Location: Elkhart, IN Posts: 6,400	i was always told that it was between the shaft that the gear slides on and the peak of the teeth on the flywheel or flexplate.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.