|
09-12-2005, 09:45 AM
|
#1 |
|
BlahBlahBlah
Join Date: Feb 2002
Location: Wa.
Posts: 20,035
|
68 vs 72 doors
i believe i know most of the differences between the two doors. im wondering if you replace the complete 72 inner door mechanics with the one from a 68 will the 68 door panel then match up to the indentation of the 72 door?
|
|
|
|
09-12-2005, 12:32 PM
|
#2 |
|
PROJECT 7DEUCE
 
Join Date: Dec 2002
Location: GRANTS PASS OR
Posts: 21,606
|
Yes I have swapped inner door guts from 71 and eariler to 72 doors and the only problem is 72 door pannels will rub the window crank because of the difference in shaft lenght...Therefore you have to run the earily door pannel's..
__________________
GO BIG GREEN  GO DUCKSMEMBER #6377 72 k-5 daily driver 6'' lift 35'' 350-350-205 slowly getting rust free. Project "7DEUCE" check out my build http://67-72chevytrucks.com/vboard/s...d.php?t=267665 Tim Powell..R.I.P EastSideLowlife..... R.I.P.. |
|
|
|
|
09-12-2005, 08:08 PM
|
#3 |
|
Registered User
Join Date: May 2000
Location: Frankfort, Kentucky, USA
Posts: 2,163
|
72 has an extra screw on the inside under the wing glass area. Not sure if that will create a problem or not.
__________________
'69 CST Short fleetside Lowered, 400 small block, 700R4, 4 wheel disc brakes, front sway bar & rear camaro sway bar (in progress) '87 V10 4x4 Short Fleetside Quad Suspension and Dual Tanks |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
