4 Blazers found - The 1947 - Present Chevrolet & GMC Truck Message Board Network

David Johnson · 09-07-2005, 10:43 PM

I found 3 Blazers and 1 Jimmy locally and was wondering if you guys could tell me what they might be worth. I know I should have pictures, but I don't. I'll try to explain them for you, bare with me.

#1 is a 72 with the buckets still there, a/c dash, very little rust (just the rockers and a little on the front floor pans), factory roll bar, trashed top, no back seat, no motor, 4 speed, no rear end.

#2 is one I haven't gotten to view yet.

#3 is a 71 with a trashed body, no rust but lots of damage, bucket seats, no back seat, no console, no a/c, no top, factory roll bar, no hood, no tailgate, all the running gear is there, no motor or tranny.

#4 is the Jimmy, 1970 or so, a/c cab (uncut) very little rust, no motor or tranny, no hood, trashed top, good tub, good tailgate, all running gear present, bucket seats, no back seat.

I know I need pics, but if you guys could ballpark it for me that would be great. I am going to try and buy all 4 plus about 5 or 6 67-72 trucks from him. I will be talking to him tomorrow, so quick input would help. Thanks in advance.

71swb4x4 · 09-07-2005, 10:58 PM

I would offer $1,000 for all four. They might be worth more, but with no pictures that's all I would go. Sounds like a couple may be not even be worth it if they were free, again, impossible to tell that without pictures so I am going off description, and thinking worst case.

71jimmy · 09-07-2005, 11:38 PM

No way to tell without pics! Even with pics it's difficult because there are never enough pics or detailed enough.

vtblazer · 09-08-2005, 06:56 AM

I was thinking $800.00 for all four.
It's going to take all four to make one from the sounds of it.

You say "very little rust" - just beware, these blazers/jimmy's hide it very very well.

Best of luck, sounds like a great find, I'd buy all four for sure.

teeitup · 09-08-2005, 07:12 AM

These guys are probably right as far as price, hard to say without pics. I'm like you Kurt, I'd buy all four too!!!

Huck · 09-08-2005, 08:26 AM

I typically will pay up to $800. for a complete Blazer if well optioned but rusted out. IF stripped out but solid tub, body---depends on condition. As mentioned, rust on a Blazer is much worse then on a truck and like an iceburg, what you see is just the smallest part with lots more hidden.
The B pillar hides rust very well with no factory access point to prevent it! SAme with the floor supports inside the torsion boxes. I would tend to consider the sum of the parts minus the cost and hassle to part out and sell. With gas at $3.+ a gallon, I am seeing a softening in the classic truck/blazer buying market as evidenced by several board members wanting to sell off their stuff in bulk and getting out of the hobby. All conderations!!

David Johnson · 09-08-2005, 09:51 AM

I'm glad I asked you guys, I probably would have paid too much. I had no idea about the rust issues since I have never owned or built one of these. I have always wanted one and probably would have let that desire blur my judgement. I was thinking the same thing about all four making one and that was what I was going to try and do. I will look closer today and if I can I will take my camara and post some pics.

LUV2XCLR8 · 09-08-2005, 04:13 PM

Quote:

Originally Posted by vtblazer

I was thinking $800.00 for all four.
It's going to take all four to make one from the sounds of it.

You say "very little rust" - just beware, these blazers/jimmy's hide it very very well.

Best of luck, sounds like a great find, I'd buy all four for sure.

David Johnson · 09-08-2005, 05:13 PM

Okay, I bought all 4. The one I hadn't seen was a 2wd

but it has been hit pretty bad

. I'm hoping to save the frame. I'll post pics as soon as I get them home. I will be parting what I don't need.

c-1072 · 09-08-2005, 05:21 PM

put me in line for any solid windshield frames you might have extra i still need a solid one for my truck .

Pop's72 · 09-08-2005, 07:43 PM

Looking forward to the pics... remember you can't take (or post) too many!

**hilljob26** · 09-08-2005, 09:24 PM

i wouldn't mind #3,it would be a good place for me to start

TexSparks · 09-08-2005, 10:29 PM

Put me in line for parts. Interested in the 4spd and transfer case.

donkey69 · 09-09-2005, 12:02 AM

Glad to hear you got em!

If you have an extra factory roll bar let me know......thanks.

72 Cheyenne K20 · 09-09-2005, 03:05 AM

Congrats on the Blazers, put me inline for a roll bar also.

Thanks, Scott

masterbeavis · 09-17-2005, 12:15 PM

any updates or pics?

cnshoot · 09-17-2005, 06:54 PM

call me i need one of these with decent tub and doors 1-318-401-1623

09-08-2005, 07:12 AM	#5
teeitup Just like to part out trucks!! Join Date: Nov 2001 Location: Meriden, Ks-North of Topeka 10 miles Posts: 27,396	These guys are probably right as far as price, hard to say without pics. I'm like you Kurt, I'd buy all four too!!! __________________ 67 Chev swb stepside 4x4 283 4 speed SOLD 72 blazer 4x4 4 speed Cheyenne 72 GMC swb 4x4 fleet 4 speed, original paint 1958 Cameo (one of 1405 built, it was my dads) 2020 chevy Apex 4x4 crew cab 1969 Z28 with the 302 1980 chevy swb 4x4 1964 chevell Malibu SS 1976 K20, sold new originally out of my dads chevy dealership Members that I've met, over 200 probably closer to 300 in the 12 years I've been on this site, everyone I met "It was a pleasure"

09-08-2005, 08:26 AM	#6
Huck Senior Member Join Date: Jun 2001 Location: Shelbyville, KY Posts: 3,269	Blazers value I typically will pay up to $800. for a complete Blazer if well optioned but rusted out. IF stripped out but solid tub, body---depends on condition. As mentioned, rust on a Blazer is much worse then on a truck and like an iceburg, what you see is just the smallest part with lots more hidden. The B pillar hides rust very well with no factory access point to prevent it! SAme with the floor supports inside the torsion boxes. I would tend to consider the sum of the parts minus the cost and hassle to part out and sell. With gas at $3.+ a gallon, I am seeing a softening in the classic truck/blazer buying market as evidenced by several board members wanting to sell off their stuff in bulk and getting out of the hobby. All conderations!!

09-08-2005, 05:21 PM	#10
c-1072 Registered User Join Date: Sep 2004 Location: rochester NY Posts: 777	windshield frame put me in line for any solid windshield frames you might have extra i still need a solid one for my truck .

09-08-2005, 07:43 PM	#11
Pop's72 It's ok to stare... Join Date: Dec 2004 Location: San Jose, CA Posts: 669	Looking forward to the pics... remember you can't take (or post) too many! __________________ -Matt 1971 Blazer/Jimmy : Factory 2WD, Factory AC, Crate 350

09-08-2005, 09:24 PM	#12
hilljob26 Registered User Join Date: Dec 2004 Location: Gypsum Kansas 67448 Posts: 1,681	i wouldn't mind #3,it would be a good place for me to start __________________ 21 2500hd duramax 58 apache HILLJOB GRAPHIX--for all your graphic needs My build thread http://67-72chevytrucks.com/vboard/s...d.php?t=542497 LS ENGINE SWAP INFORMATION THREAD http://67-72chevytrucks.com/vboard/s...d.php?t=377348 4l60 to an NP205 http://67-72chevytrucks.com/vboard/s...43#post3697343

09-07-2005, 10:43 PM	#1
David Johnson Registered User Join Date: Dec 2004 Location: Shawnee, OK Posts: 614	4 Blazers found I found 3 Blazers and 1 Jimmy locally and was wondering if you guys could tell me what they might be worth. I know I should have pictures, but I don't. I'll try to explain them for you, bare with me. #1 is a 72 with the buckets still there, a/c dash, very little rust (just the rockers and a little on the front floor pans), factory roll bar, trashed top, no back seat, no motor, 4 speed, no rear end. #2 is one I haven't gotten to view yet. #3 is a 71 with a trashed body, no rust but lots of damage, bucket seats, no back seat, no console, no a/c, no top, factory roll bar, no hood, no tailgate, all the running gear is there, no motor or tranny. #4 is the Jimmy, 1970 or so, a/c cab (uncut) very little rust, no motor or tranny, no hood, trashed top, good tub, good tailgate, all running gear present, bucket seats, no back seat. I know I need pics, but if you guys could ballpark it for me that would be great. I am going to try and buy all 4 plus about 5 or 6 67-72 trucks from him. I will be talking to him tomorrow, so quick input would help. Thanks in advance.

09-07-2005, 10:58 PM	#2
71swb4x4 Senior Member Join Date: Nov 2003 Location: Brookings, SD Posts: 10,497	I would offer $1,000 for all four. They might be worth more, but with no pictures that's all I would go. Sounds like a couple may be not even be worth it if they were free, again, impossible to tell that without pictures so I am going off description, and thinking worst case. __________________ Some people are like slinkies, they aren't good for anything, but you can't help but smile when you see one tumble down the stairs.

09-07-2005, 11:38 PM	#3
71jimmy Registered User Join Date: Mar 2004 Location: Sacramento, CA Posts: 1,084	No way to tell without pics! Even with pics it's difficult because there are never enough pics or detailed enough. __________________ '71 Jimmy, 350, SM465, NP205, 2in Tuff Country lift, 33s on rallies, TBI, softtop and hardtop "If life was fair you'd be able to afford one of each and a garage large enough to house them all."

09-08-2005, 06:56 AM	#4
vtblazer Registered User Join Date: Oct 2003 Location: Central Vermont Posts: 8,538	I was thinking $800.00 for all four. It's going to take all four to make one from the sounds of it. You say "very little rust" - just beware, these blazers/jimmy's hide it very very well. Best of luck, sounds like a great find, I'd buy all four for sure.

09-08-2005, 09:51 AM	#7
David Johnson Registered User Join Date: Dec 2004 Location: Shawnee, OK Posts: 614	I'm glad I asked you guys, I probably would have paid too much. I had no idea about the rust issues since I have never owned or built one of these. I have always wanted one and probably would have let that desire blur my judgement. I was thinking the same thing about all four making one and that was what I was going to try and do. I will look closer today and if I can I will take my camara and post some pics.

09-08-2005, 05:13 PM	#9
David Johnson Registered User Join Date: Dec 2004 Location: Shawnee, OK Posts: 614	Okay, I bought all 4. The one I hadn't seen was a 2wd but it has been hit pretty bad . I'm hoping to save the frame. I'll post pics as soon as I get them home. I will be parting what I don't need.

09-08-2005, 10:29 PM	#13
TexSparks Registered User Join Date: Jun 2003 Location: Mt. Vernon, Texas Posts: 65	Put me in line for parts. Interested in the 4spd and transfer case. __________________ '72 4x4 Blazer (in the works)

09-09-2005, 12:02 AM	#14
donkey69 JB-80 &quot;Twice as Good&quot; Join Date: Jun 2004 Location: Central, MN Posts: 354	Glad to hear you got em! If you have an extra factory roll bar let me know......thanks. __________________ HEY NOW!

09-09-2005, 03:05 AM	#15
72 Cheyenne K20 Registered User Join Date: Feb 2003 Location: Staunton, Virginia Posts: 554	Congrats on the Blazers, put me inline for a roll bar also. Thanks, Scott

09-17-2005, 12:15 PM	#16
masterbeavis Having issues Join Date: Jul 2005 Location: Eldorado Ca, an hour east of sacramento Posts: 696	any updates or pics? __________________ Quando Omni Flunkus Moritati. The Man's Prayer: "I'm a man, but I can change, if I have to, I guess."



Register or Log In To remove these advertisements.

09-17-2005, 06:54 PM	#17
cnshoot Registered User Join Date: Jan 2003 Location: minden Posts: 358	call me i need one of these with decent tub and doors 1-318-401-1623 __________________ 72 cst 2wd blazer sb soon to have tilt manual 72 gmc swb fleet 2wd bb air tilt auto 93 c/3500 crew-cab dually 03 chevy suburban LT quadrasteer c/2500 4x4

Register or Log In To remove these advertisements.