super t-10 swap - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Jim_PA · 11-02-2005, 09:15 AM

I'm taking out the TH-350 and putting in a super t-10. Is there a good way to bring the shifter up through the floor? Just measure and cut out a hole? Or is there a better way to do this?

I would like to make a nice clean install.

mooneyes · 11-02-2005, 03:45 PM

...when i did mine..i put the tranny in as far as i could with a jack to get a round about placement...then cut a small hole just to start the shifter up through..then trimmed from there..........

Jim_PA · 11-02-2005, 04:24 PM

Did you use the hurst comp+ shifter for trucks? Or something else? Also - did you have to shorten the driveshaft? Lastly, any pics?

thanks-

11-02-2005, 09:15 AM	#1
Jim_PA Registered User Join Date: May 2005 Location: PA Posts: 2,696	super t-10 swap I'm taking out the TH-350 and putting in a super t-10. Is there a good way to bring the shifter up through the floor? Just measure and cut out a hole? Or is there a better way to do this? I would like to make a nice clean install.

11-02-2005, 03:45 PM	#2
mooneyes Registered User Join Date: Jan 2002 Location: Slippery Rock PA USA Posts: 1,692	Re: super t-10 swap ...when i did mine..i put the tranny in as far as i could with a jack to get a round about placement...then cut a small hole just to start the shifter up through..then trimmed from there.......... __________________ Ken Lyons, Slippery rock pa 68 short step 327 t10 4 gear 72 2wd blazer project 70 lwb 305/700r driver 78 caprice project 02 cavalier D.D ( hate it!!)

11-02-2005, 04:24 PM	#3
Jim_PA Registered User Join Date: May 2005 Location: PA Posts: 2,696	Re: super t-10 swap Did you use the hurst comp+ shifter for trucks? Or something else? Also - did you have to shorten the driveshaft? Lastly, any pics? thanks-



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.