|
01-01-2006, 10:45 AM
|
#1 |
|
The start of the $ pit!
Join Date: Jul 2005
Location: garland, Tx
Posts: 153
|
help with tilt column
I purchased a tilt column off of the site last summer and just got around to replacing it and have run into an issue.
The shaft that runs through the center has a spline end (looks like a gear) and will not fit. Anyone run into this issue before? Thanks for the help. |
|
|
|
01-01-2006, 01:34 PM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,947
|
Re: help with tilt column
I tried to find you Friday night but had no luck.
When will you be out working on it? I can come by & look & see what you're up against. I also had a set of rollers (wheels/tires) to show you & see if you might be interested. My brother is coming over today @ 2pm for x-mas gift exchange for the kids so later this afternoon or tomorrow?
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
