|
09-26-2002, 06:21 PM
|
#1 |
|
Registered User
Join Date: Dec 2001
Location: Philadelphia, pa. U.S.A.
Posts: 87
|
tilt front end?
a welder i work with is building a 72 and was thinking about trying to make a tilt front end out of his truck. I know a couple of people on here have done this and I told him I'd ask to know what steps to take and what problems you ran into. any pics would be helpful also
thank you |
|
|
|
09-26-2002, 06:31 PM
|
#2 |
|
Member since 2000
Join Date: Dec 2000
Location: Mountain View Ca / Mexico
Posts: 7,879
|
i hope this might help in some way
http://www.usbody.com/ on the side menu go to 67-72chevy trucks, if you got a modem connection you better start a puzzle, lol. i'm playing might take a while to load but they have a 67 front clip kit that tilts. |
|
|
|
|
09-26-2002, 07:10 PM
|
#3 |
|
Registered User
Join Date: Dec 1999
Location: BRADENTON FLA
Posts: 3,269
|
We have 2 67-8 tilt cowl front ends on order, both are part# FCGI-67e in their catalog. e-mail for prices or information.
__________________
Rest in Peace Ed. Thanks for all the good times. |
|
|
|
|
09-26-2002, 10:22 PM
|
#4 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
A glass tilt would be by far the easiest way to go,& would save a little weight. my longhorn has a steel tilt that I set up over a winter,but was a lot of work. I dont have pics at this time, but would be glad to try to run over details.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
