|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-03-2006, 02:53 PM
|
#1 |
|
2WD Jimmy
 
Join Date: Mar 2005
Location: Davis County, Utah
Posts: 2,563
|
Clutch linkage questions
The attachment is a picture of part of my clutch linkage. This is the peice that bolts to the engine block that supports the Z-bar on the engine side. It is an NOS item that I purchased years ago. You can see the felt seal below the ball joint... my question is this, is there supposed to be some kind of an O-ring on that ball joint where that groove is machined around the circumference?
Also, anyone got a picture of the rod going into the cltch fork? Im using a GM heavy duty clutch fork but there is no hole in the end, just a dimple? Thanks in advance... Tom |
|
|
|
05-03-2006, 03:50 PM
|
#2 |
|
Registered User
Join Date: Sep 2005
Location: Smith Mountain Lake Virginia
Posts: 1,537
|
Re: Clutch linkage questions
perhaps a "C" clip ???????
__________________
"A cat will almost always blink when hit between the eyes with a ball peen hammer" (you don't always have to state the obvious) Wear your PPE! You can eat with false teeth but you can't see with a false eye. 1959 Studebaker Silverhawk 350/400 1972 C10 L6 3OTT 2005 F350 - Built - whew! |
|
|
|
|
05-03-2006, 07:57 PM
|
#3 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Clutch linkage questions
The groove is to hold grease since the "Z" bar has some movement relative to the engine in addition to the clutch release motion.
Jim |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
