3/4 ton vs 1/2 ton 2wd - The 1947 - Present Chevrolet & GMC Truck Message Board Network

skanave · 05-11-2006, 08:03 PM

just curious what the biggest difference is between 3/4 ton and 1/2 ton

i assume bigger rear axle/8 lug

anything else?

found a 72 3/4 Burb for a good price and i have always wanted to build a bagged cruiser out of one

*edit* i did a search and turned up nothing, sorry if this has been asked before

**uncle** · 05-11-2006, 08:28 PM

You can change the front and rear to 1/2 ton pretty easy. Change the rear end and panhard bar. On the front change outer tie rods,upper ball joints and the whole lower a-frame(including ball joints)and spindle.

skanave · 05-11-2006, 08:30 PM

Quote:

Originally Posted by uncle

You can change the front and rear to 1/2 ton pretty easy. Change the rear end and panhard bar. On the front change outer tie rods,upper ball joints and the whole lower a-frame(including ball joints)and spindle.

thanks for the input, i figured it wasnt too much of an issue but i didnt wanna get it and find out i was SOL

05-11-2006, 08:03 PM	#1
skanave Registered User Join Date: May 2006 Location: Clovis, CA Posts: 80	3/4 ton vs 1/2 ton 2wd just curious what the biggest difference is between 3/4 ton and 1/2 ton i assume bigger rear axle/8 lug anything else? found a 72 3/4 Burb for a good price and i have always wanted to build a bagged cruiser out of one edit i did a search and turned up nothing, sorry if this has been asked before Last edited by skanave; 05-11-2006 at 08:04 PM.

05-11-2006, 08:28 PM	#2
uncle Senior Member Join Date: Aug 2003 Location: Conyers,Ga. Posts: 7,288	Re: 3/4 ton vs 1/2 ton 2wd You can change the front and rear to 1/2 ton pretty easy. Change the rear end and panhard bar. On the front change outer tie rods,upper ball joints and the whole lower a-frame(including ball joints)and spindle.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.