|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
06-02-2006, 11:32 PM
|
#1 |
|
Registered User
Join Date: Jul 2005
Location: Kernersville, NC
Posts: 599
|
Re: WHERE was he hiding/nesting and how did he get out?
couple mouse traps and some posion should do the trick, at least u did find there bones. pulled the tank no my '69 when i first got her and there were a whole lot of dead maggots and some bones behind the tank. chris.
__________________
its a work in progess. 71 c-10 lwb, in the middle of frame off restoration. 69 c-10 swb, drag truck, 406 sbc, balanced, comp 292 cam, ported, polished, gasket matched, and bowl blended pro comp 210cc heads, 2.02/1.60 ferrea valves,1.6 roller rockers, re curved hei with msd 6al box, 2-step rev limter, accel 300+ wires, ported victor jr intake, holley 750 double pumper carb, dynomax 1 5/8 headers, 4 spd munci m-20 with super case and iron midplate, mr. gasket vertigate shifter, 5.38 pro gears with full spool, 33 spline moser axles and c-clip elimators, line-loc, 5 gal fuel cell, holley blue pump.   7.807 @ 88.37mph 1.60 60FT 80 g-20 van, tow rig, cammed 305, th350, 10 bolt 88 jeep wrangler, dd, 258, ax-15 swap, 4.5" lift, 33x12.50's, lockers, 3.55's |
|
|
|
06-02-2006, 11:39 PM
|
#2 |
|
Senior Member
 Join Date: Jan 2000
Location: Arlington, VA
Posts: 398
|
Re: WHERE was he hiding/nesting and how did he get out?
Mice liked the heater core when I first bought my truck.
Must have been a roll of papertowels/fast food napkins lodged in around the core...no wonder the heater was lame until I cleaned it out. |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
