i need a bed floor patch

[meathead95]

from the end of the bed like 2' in and 3' wide

[ol yellow 72]

i can get ya what u need i have an old floor laying here, just show me what section u need and ill hook ya up

[Huskerboy2]

Not to hijack Meathead's thread, but if you're cutting up a floor, I'd take some as well. I need a section of the very end as well, more like 4 inches in and around 8 inches wide. Also, I could use a section around the wheel well openings in the floor. Both sides. Just a couple of inches in.

[meathead95]

alright here is what i need go to the rear outer corner of the wheel tub and go back forward one bolt start there and cut inward 5 ribs and then all the way to the back of the bed i need the end of the floor at the tailgate where it wraps over the crossmember so be sure to save that for me i need this on both sides
thanks
keith

[ol yellow 72]

meathead i only have one side the passanger side is tore up
if ull find a pict and mark what yall need ill see what i can do

[meathead95]

i couldnt find a pic if youll go to the center of where the wheel tub would go and cut inward 5 ridges and all the way back to the end where the tailgate is that will do me good

[ol yellow 72]

i have a good drives side passenge side is shot

[meathead95]

thats fine